Worn struts on the Ford Escape do extra than simply make for a rougher experience when driving in the automobile, which is named a crossover SUV. Warn struts may also improve the stopping distance necessary, as well as trigger irregular put on on the tires. For those causes alone, it will be important that you simply change the struts as soon as you realize they’re dangerous, earlier than additional injury develops. It’s not essential to take the Ford to a storage, since you can set up the struts yourself, in your driveway. This article details the set up of the entrance struts.
Ford Escape strut Installation Instructions
1. Disconnect the destructive battery cable with the intention to prevent accidental deployment of the air bag. Place a set of wheel chocks behind the rear wheels of the Ford. Elevate the entrance of the car on the facet that you are beginning with using the automobile jack. Place a jack stand underneath the Ford near the jacking level and raise it to the frame.
2. Loosen the lug nuts with the lug wrench and take away the wheel from the Escape. Remove the nut attaching the brake hose bracket to the strut using a wrench and pull the bracket from the strut. Disconnect the ABS harness from the strut in case your car has antilock brakes. Take away the stabilizer bar hyperlink nut using a wrench and push the bar off to the side.
3. Place the spring compressor on the coil spring and tighten it sufficient to take away the stress from the strut. Take away the bolts attaching the strut to the steering knuckle using a socket and ratchet. You could have to use a wrench to hold the nut to maintain it from turning with the bolt.
4. Take away the three nuts on the high of the strut utilizing a wrench. Pull the strut assembly from under the Ford. Take away the coil spring from the old strut and place it on the new one. Place the brand new strut under the Escape and secure it by tightening the three higher nuts with a wrench.
5. Set up the bolts and mount the strut to the steering knuckle. Tighten the bolts with a socket and ratchet. You will have to carry the nuts with a wrench to keep them from turning as you tighten the bolts. Remove the spring compressor from the coil spring. Pull the stabilizer bar into place and tighten the nut with a wrench.
6. Plug within the ABS sensor if your automobile has antilock brakes. Attach the brake hose bracket to the strut and tighten the nut with a wrench. Set up the wheel on the Escape and tighten the lug nuts with the lug wrench. Remove the jack stand from beneath the Ford. Lower the automobile to the ground. Repeat the process on the opposite wheel.
